Manufacturing Technician (Operator)

Dana is a global leader in the supply of highly engineered driveline, sealing, and thermal-management technologies that improve the efficiency and performance of vehicles with both conventional and alternative-energy powertrains. Serving three primary markets - passenger vehicle, commercial truck, and off-highway equipment - Dana provides the world's original-equipment manufacturers and the aftermarket with local product and service support through a network of nearly 100 engineering, manufacturing, and distribution facilities.

2nd & 3rd Shifts earn an additional $0.50 cents per hour for shift premium

GENERAL SUMMARY : Set-up, operate and maintain standard and complex manufacturing processes consistent with approved engineering standards and quality parameters. To be an active participant in line/cell teams, contribute to the company's vision and goals, while safely operating production equipment.

______________________________________________________________________

* 1. Operate equipment to accepted safety and production standards.

* 2. Maintain clean and safe work area utilizing 5S methodologies and in accordance with hazard assessment.

* 3. Actively participate in problem solving, continuous improvement and teaming activities utilizing the following methodologies:

- Use and maintain product and process controls utilizing Dynamic Control Plan (DCP) methodology.

- Participate in problem solving activities utilizing 8D and Poka-Yoke methodology.

- Strive for quality improvement and cost reduction, utilizing continuous improvement methodologies.

* 4. Maintain and utilize Statistical Process Control (SPC), Quality Operating System (QOS) measurables and all Dana reporting documentation.

* 5. Maintain and verify all quality gaging, Poka-Yokes and mistake proof devices in accordance with Dana engineered specifications.

* 6. Verify and maintain just-in-time inventory based on pull system.

* 7. Ensure that equipment is serviced as required utilizing Total Productive Maintenance (TPM) methodology.

* 8. Set-up all equipment in the entire cell to accepted engineering standards, utilizing quick changeover methodology.

* 9. Determine what repairs are required based on MRB documents.

*10. Must be able to use hand gages, (micrometers, calipers, snap gages and master gages).

* 1. High school diploma, GED or equivalent work experience.

* 3. Ability to communicate effectively in both written and verbal form, as required.

* 5. Must be willing to assume responsibility and be accountable for their actions.

* 6. Create and work in an environment of respect and integrity.

* 8. Must have the ability to be trained in skills required per the training matrix.

*9. Must be able to lift up to 50 pounds without a manipulator (lift assist).